COUSSINETS SKF PDF

COUSSINETS SKF PDF

Comme pour les coussinets et les bandes composites, SKF fabrique de série des rondelles de butée composites à partir de matériaux composites PTFE et POM. For additional information about the meaning and limitations of the product data, refer to SH bushings. Imprimer cette page; Partager. d, 35, mm. D, 60, mm. D1, 68, mm. L, 37, mm. L1, 49, mm. B, , mm. Calculation data. Max. torque, Mv, , N·m. Max. axial load, Pa, 41, kN. Mounting.

Author: Zuran Tezragore
Country: Mayotte
Language: English (Spanish)
Genre: Art
Published (Last): 2 April 2017
Pages: 288
PDF File Size: 10.63 Mb
ePub File Size: 12.9 Mb
ISBN: 817-7-52135-579-6
Downloads: 83646
Price: Free* [*Free Regsitration Required]
Uploader: Kigajind

Mounting Skill and care in mounting are prerequisites for long bearing service life. In addition, cleanliness, and understanding the causes of premature bearing failure can help too.

Coussinets à enroulement filamentaire SKF

Check that the counter surface shaft seat and other components such as the housing are clean, deburred and that they do not contain any abrasive particles. Check also the shaft for sharp edges, burrs or surface defects, which could damage the sliding surface of the bushings. Once all the components have been cleaned and checked, the bushing is ready to be installed.

  BIZ INSANLAR PEYAMI SAFA PDF

To install bushings, with or without a flange, SKF recommends using a mounting dolly particularly for composite fig. To do skt, place an O-ring on the dolly to keep the bushing in position.

Rondelles de butée

Then drive the bushing into place with a mechanical or hydraulic press or by tapping the dolly lightly with a hammer. To facilitate the mounting of small bushings, apply a light coating of oil or grease to the housing bore.

For larger bushings, SKF recommends using a mounting ring fig. SKF also recommends, particularly for larger bushings where more force is required that they be cooled before mounting. Care should always be taken when mounting FW bushings not to damage the sliding layer or side faces.

To facilitate mounting FW busings, the bushing may be split lengthwise into two halves by using a diamond coated grinding wheel. Sufficient cooling fluid should be applied as well to avoid excessive temperatures, as they can destroy the bushing. Coussinrts position of the lubrication groove of solid bronze bushings depends on whether it is an oscillating or rotating or movement and, for the latter, whether oil or grease lubrication is applied fig.

  JOHN RENBOURN FOLK BLUES AND BEYOND PDF

When mounting, thrust slf should be positioned so couxsinets the steel backing abuts the housing wall. If composite plain bearings, for example strips, are to be located in a housing using an adhesive, the adhesive should be suitable for the expected operating temperature and should have suitable expansion, aging resistance, strength and curing properties.

Joints à frottement mécanique, coussinets SH

If no operational experience is available, SKF recommends contacting an adhesive manufacturer for advice. When applying an adhesive, care should be taken so that no adhesive reaches the sliding surface.

SKF sintered bronze bushings are impregnated with a lubricant and.

Otherwise when the bushing comes in contact with absorbent material it may wick the oil away very quickly. Imprimer cette page Partager Partager cette page.